Table of Contents
Advertisement
Configuring the antenna input
source for the ANT/CABLE terminal
1
From the SETUP menu, highlight ANT/CABLE
In.
SETUP
Menu Language
ANT/CABLE In
Auto Tuning
Manual Tuning
TV Settings
Manual Setting
AV Connection
PC Settings
2
Press C or c to select the input source (Antenna
or Cable) for the ANT/CABLE input on the TV
and press O.
Programming channels into the
TV's channel memory
When you press < or , on the remote control or TV
control panel, your TV will stop only on the channels
you programmed into the TV's channel memory.
Follow the steps below to program channels into the
TV's channel memory.
Auto Tuning
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
• You must configure the ANT/CABLE input source before
programming channels.
• If the ANT/CABLE input is configured for Cable, the
automatic channel programming process erases
channels that were previously programmed into the TV's
memory.
• If the ANT/CABLE input is configured for Antenna, the
automatic channel programming process adds newly
found channels to the existing set of programmed
channels (and does NOT erase channels that were
previously programmed into the TV's memory.) To
remove an Antenna source channel from the memory,
you must set it to Skip.
• To tune the TV to a channel not programmed in the
channel memory, you must use the Channel Number
buttons on the remote control.
Chapter 5: Setting up your TV
• Programming channels when the ANT/CABLE input is
1
2
English
3
Antenna
4
Manual Tuning
After automatically programming channels into the
channel memory, you can manually enter channels if
the physical channel is known.
1
2
If channels are found, they will be listed at the
bottom of the screen. Analog channels will be noted
by an "ATV" symbol, digital channels by a "DTV"
symbol.
configured for Cable will take substantially longer than
when the antenna input is configured for Antenna. This
is normal; however, once channel programming is
finished, you should not have to repeat the programming
process again unless your Cable TV service lineup
changes significantly.
Configure the ANT/CABLE input, if you have
not already done so (- left-hand column).
From the SETUP menu, highlight Auto Tuning.
A screen will appear warning that previous
programs and settings will be deleted.
Auto Tuning
Previous settings will be lost! Press EXIT for
no change.
Start Scan
Press T to start Auto Tuning.
The TV will automatically cycle through all the
channels, and store all active channels in the
channel memory. When Auto Tuning is finished,
press < or , to view the programmed channels.
From the SETUP menu, highlight Manual
Tuning and press T.
Use the Channel Numbers on the remote control
to enter the channel number (up to three-digit
number) and press T.
37
Hide quick links:
Advertisement
Table of Contents
