Table of Contents
Advertisement
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface and
disengage the drives.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Wait for all moving parts to stop before leaving
the operating position.
5. Ensure that the machine is secure from
movement and allow surfaces to cool before you
begin to work on it.
6. Clean the machine of any debris on the machine
deck or rear part of the machine to ease
installation.
2
Installing the Weight
Parts needed for this procedure:
1
Weight tray
1
Left weight-tray mount
1
Right weight-tray mount
1
Suitcase weight—16 kg (35 lb)
1
Retaining rod
2
Bolt (3/8 x 1-1/4 inches)
4
Flange nut (3/8 inch)
2
Carriage bolt (3/8 x 1 inch)
2
Self-tapping bolt (5/16 x 3/4 inch)
Procedure
CAUTION
The bagger changes the weight distribution of
the machine. Operating the machine without
the front weights may cause an unstable
condition, which could result in a loss of
control.
Ensure the front weights are properly installed
before operating the machine with the bagger
attachment.
1. Remove the existing bolt and nut from the left
and right side of the platform where you will
install the weight-tray mounts.
2. Use the 2 self-tapping bolts (5/16 x 3/4 inch), 2
bolts (3/8 x 1-1/4 inches), and flange nuts (3/8
inch) to secure the left and right weight-tray
mounts to the machine
6
(Figure
3).
Advertisement
Table of Contents
