Toro Greensmaster TriFlex 3300 Operator's Manual page 42

Figure 43
1. Prop (not provided)
Installing the Cutting Units
1. Lift up on the footrest and swing it open, allowing
access to the center cutting unit position
44).
CAUTION
The footrest can pinch fingers if it falls
into the closed position.
Keep your fingers clear of the area where
the footrest seats while it is open.
Figure 44
1. Footrest—closed
2. Position the cutting unit under the center
suspension arm.
3. With the latches on the suspension-arm bar
pointing up (i.e., open)
suspension arm down so that the bar fits over
the bar across the top of the cutting unit
46).
g014596
2. Bedbar-adjusting-screw
nut (2)
(Figure
g014602
2. Footrest—open
(Figure 45), push the
(Figure
1. Latch—closed position
2. Suspension-arm bar
1. Suspension-arm bar
4. Close the latches down and around the
cutting-unit bar and lock them in place
45).
Note:
You can hear a click and feel when the
latches are properly locked in place.
5. Coat the spline shaft of the cutting unit motor
with clean grease
6. Insert the motor into the left side of the cutting
unit (as viewed from the operator's position) and
pull the motor retaining bar on the cutting unit
toward the motor until you hear a click from both
sides of the motor
42
Figure 45
3. Latch—open position
Figure 46
2. Cutting-unit bar
(Figure 47).
(Figure 47).
g014609
g014611
(Figure