Pre-Maintenance Procedures; Pre-Maintenance Safety; Engine Maintenance; Engine Safety - Toro Greensmaster TriFlex 3300 Operator's Manual

Traction unit
Hide thumbs Also See for Greensmaster TriFlex 3300:
Table of Contents

Advertisement

Pre-Maintenance
Procedures

Pre-Maintenance Safety

Before adjusting, cleaning, repairing, or leaving
the machine, do the following:
– Park the machine on a level surface.
– Move the throttle switch to the low-idle position.
– Disengage the cutting units.
– Lower the cutting units.
– Ensure that the traction is in neutral.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
– Allow machine components to cool before
performing maintenance.
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
Use jack stands to support the machine or
components when required.
Carefully release pressure from components with
stored energy.

Engine Maintenance

Engine Safety

Shut off the engine before checking the oil or
adding oil to the crankcase.
Do not change the governor speed or overspeed
the engine.

Servicing the Air Cleaner

Service Interval: Every 50 hours—Service
the air-cleaner foam element
(more frequently when operating
conditions are dusty or dirty).
Every 100 hours—Service the air-cleaner
paper element (more frequently when operating
conditions are dusty or dirty).
1.
Clean the air-cleaner cover
1. Air-cleaner cover
2.
Release the locking clips and remove the
air-cleaner cover.
3.
Remove the wing nut securing the elements to
the air-cleaner body
4.
If the foam element is dirty, remove it from the
paper element
as follows:
A.
Wash the foam element in a solution of
liquid soap and warm water. Squeeze it to
remove dirt.
B.
Dry it by wrapping it in a clean rag. Squeeze
the rag and foam element dry.
Important:
element, do not twist it; the foam may
tear.
30
(Figure
26).
Figure 26
(Figure
27).
(Figure
27). Clean it thoroughly,
When drying the foam
g005125

Advertisement

Table of Contents
loading

This manual is also suitable for:

04510

Table of Contents