Toro Greensmaster TriFlex 3300 Operator's Manual page 38

2. Check the fluid level according to the tank on
your machine:
•
If your machine has a fuel gauge at the
top of the fuel tank, locate the dipstick for
the hydraulic system at the top of the leak
detector tank (Figure
step 3.
Figure 36
1. Dipstick
2. Hydraulic tank plug
•
If your machine has a fuel sight gauge at
the side of the fuel tank, locate the dipstick
for the hydraulic system at the top of the
hydraulic tank
step 5.
Note:
If the fluid level is between the 2
marks on the sight window, the fluid level is
sufficient.
36) and proceed to
3. Hydraulic tank
4. Leak-detector tank
(Figure 37) and proceed to
1. Dipstick
3. Remove the dipstick and wipe it with a clean
rag, then screw the dipstick back into the tank.
4. Remove the dipstick and check the fluid level. If
the fluid is between the marks on the dipstick,
the level is sufficient. If the fluid level is not
g228585
between the marks, more fluid is needed.
5. Remove the cap from the hydraulic fluid tank
and slowly fill the tank with the appropriate
high-quality hydraulic fluid until the level is
between the 2 marks on the sight window or
dipstick.
Note:
Do not mix different types of hydraulic
fluid.
6. Install the cap.
Note:
Perform a close visual inspection of the
hydraulic components. Inspect them for issues
(e.g., leaks, loose fasteners, missing parts, and
improperly routed lines). Make any necessary
corrections.
38
Figure 37
2. Hydraulic tank
g228586