Toro Greensmaster TriFlex 3300 Operator's Manual page 16

Figure 14
1. Ignition switch
2. Choke lever
3. Functional-control lever
4. Raise/lower mow control
Choke Lever
To start a cold engine, close the carburetor choke
by pushing the choke lever forward
the C position. After the engine starts, regulate
LOSED
the choke lever to keep the engine running smoothly.
As soon as possible, open the choke by pulling the
lever rearward to the O
requires little or no choking.
Raise/Lower Mow Control
Moving the control (Figure
operation lowers the cutting units and starts the reels.
Pull back on the control to stop the reels and raise
the cutting units. To stop the reels without raising the
cutting units, pull back on the control momentarily
and releasing it. Start the reels by moving the control
forward.
Functional-Control Lever
The functional-control lever
traction selections plus a N
shift from mow to transport or transport to mow (not
to neutral) while the machine is in motion; no damage
will result.
•
R position—neutral position; use when
EAR
backlapping the reels
•
M position—use when cutting grass
IDDLE
•
F position—use when driving the machine
RONT
between job sites
5. Throttle lever
6. Service-indicator light
7. Engine-oil-pressure light
8. Leak-indicator light
(Figure 14) to
position. A warm engine
PEN
14) forward during cutting
(Figure 14) provides 2
position. You can
EUTRAL
Ignition Switch
Insert the key into the switch
clockwise to the S
Release the key as soon as the engine starts;
the key moves to the O
counterclockwise to the S
engine.
Engine-Oil-Pressure Light
The light (Figure
drops below a safe level.
Service-Indicator Light
g032817
The service-indicator light
when the machine sensors detect an issue with 1 of
the systems of the machine. If this light illuminates,
stop what you are doing and drive to a safe location
where you or a service technician can diagnose
the problem. For more information on diagnosing
system issues using the service indicator light, refer to
Diagnosing the Service Indicator Light (page
Leak-Indicator Light
This light illuminates and an alarm sounds if the
hydraulic fluid level drops in the hydraulic reservoir;
refer to Operating the Leak Detector (page 41)
Checking the Hydraulic-Fluid Level (page
Hour Meter
The hour meter
the machine has operated. It starts to function
whenever you rotate the ignition switch to the O
position.
16
(Figure 14) and turn it
position to start the engine.
TART
position. Turn the key
N
position to shut off the
TOP
14) glows if the engine-oil pressure
(Figure 14) illuminates
(Figure 15) indicates the total hours
46).
and
37).
N