How To Operate Time Shift - Sharp AQUOS LC-70LE741E Operation Manual

Other useful features

How to operate Time shift +

This function enables you to pause the digital TV
or satellite programme you are watching and start
watching it again from the paused scene.
CAUTION
• Do not unplug the AC cord during time shift timer
setting or time shift recording.
• When the AC cord is unplugged and the TV is turned
off:
− The time shift timer setting is cancelled.
− Recorded data is deleted.
• Time shift recording may be automatically stopped
when signal reception is poor.
• Only this TV can playback the programme recorded
on the USB storage device connected to this TV. The
programmes cannot playback on other TV or PC.
SHARP corporation bears no responsibility regarding
compensation for content when recording cannot does
not take place, loss of recorded data or other direct or
indirect damages related to these matters. Please be
forewarned.
E
Buttons for time shift operation
Remote control unit Control panel
Buttons Description
Start recording the programme you are
watching.
• You cannot playback the recorded
REC E
programme until approximately three
seconds after pressing REC E to
start recording.
Stop recording.
REC STOP H
Playback the recorded programme.
I
Stop the programme in playback and
go back to the real time broadcast
H
(live).
Pause the programme in playback
(time shift recording continues).
F
• This function is released in 15
minutes.
Reverse (each time you press this
button, the reverse speed changes in
S
three levels).
Fast forward (each time you press this
button, the fast forward speed changes
J
in three levels).
Jump backward to the previous
K
chapter point*.
Jump forward to the next chapter
L
point*.
Playback will resume after jumping
backward by the time interval you set
a
in "Jump time setting" (Page 47).
Playback will resume after jumping
forward by the time interval you set in
b
"Jump time setting" (Page 47).
* Chapter points are fixed at 10 minute increments.
45
NOTE
• Refer to Regarding "Select recording device" (Page 27),
when the buttons for time shift do not work.
• Instead of pressing buttons on the remote control
unit, most of the operations shown to the left are also
available on the screen with the control panel. You can
call up this control panel by pressing CONTROL on the
remote control unit or select "Control (Time shift)" from
"HOME" > "TV Menu" > "Setup" > "Option" > "Option
for view".
• The "Audio description setting" menu does not work
during time shift playback.
• When the amount of memory used for time shift reaches
"Full" and the blue point is around the left edge of the
bar (see and in the Counter section on page 47),
 
you cannot operate some functions (F (Pause), S
(Reverse), K (Jumping backward to the previous
chapter point) a (Jumping backward by the time
interval you set in "Jump time setting")).
• Time shift recording stops if no operation detected for
three hours.
• When recording operations are not stopped manually,
recording will automatically stop after six hours.
• To release time shift, press REC STOP H, change the
DTV/SAT channel or change "INPUT".
• Some functions do not work during time shift.
• As time shift is not actually a recording function,
recorded data will be reset when the TV is turned off by
unplugging the AC cord.
• Time shift does not start automatically, but starts only
when REC E is pressed or when a time shift timer
setting is started.
• The PIN is required when you use the buttons such as
S, J, K, L, a, b if you set the PIN and
any options for "Parental rating" except "None" are
selected.
• Do not disconnect the USB storage device used for
time shift during time shift operation.