Sharp AQUOS LC-70LE741E Operation Manual page 15

Quick guide
Using the Menu screen
You need to call up the OSD to perform settings for the TV. The OSD for the
settings is called "Menu". The "Menu" enables various settings and adjustments.
Display the Menu screen

Go to "HOME" > "TV Menu".
• You can also display the Menu screen with pressing the MENU button on the
side of the TV.
Selecting in the Menu

Press c/d to select the desired menu,
and then press ;. Press 6 to return to
the previous menu category.

Press c/d to select the desired sub-
menu, and then press ;.

Press a/b to select the item you want to
select/adjust, and then press ;.
Menu
CH list Setup
:Enter :Back
Picture
AV mode
OPC
Backlight
Contrast
About the guide display
The guide display below the menu bar shows
operations for the OSD.
• The bar above is an operational guide for the
remote control unit. The bar will change in
accordance with each menu setting screen.
NOTE
• "Menu" options differ according to the selected input modes, but the operating
procedures are the same.
• Items with 4 cannot be selected for various reasons.
• Some items cannot be selected depending on signal types, optional settings or
connected devices.
Selecting options

Press a/b or c/d to
configure the control for
improving TV viewing, and
then press ;.
EXAMPLE
Backlight
Yes No
[Off]
NOTE
• Refer to the guide display
below the menu bar to see
when to press the ; button.
CH list
:Select :Enter
Using Software keyboard
Use the software keyboard when you need to input text.
6 7
Char.Set
1
Caps
2
Done
3
4
Cancel
Cursor Left
5
1
Char. Set
Changes character
set into the alphabet,
numbers, symbols, etc.
2 Caps
Changes characters to
capital/lower case.
3 Done
Confirm the entry.
4 Cancel
Abort input and close
the software keyboard.
5 R/G/Y/B (Colour)
buttons
Selects the coloured
items on the screen.
Setup
:Back
NOTE
• Depending on the application, there may be a different software keyboard than the one
indicated above.
13
8
Delete
SP
Caps Char.Set Cursor Right
6 Input cursor 0 Clear
Press c/d to move the Erases the character
cursor when highlighted. string.
• When the cursor is
7 Input field
somewhere in a line:
The text you enter is
The character string to
displayed as you type
the right of the cursor
it in.
will be erased.
8 Character
• When the cursor is at
Input characters by
the right end of a line:
using these buttons.
The entire line will be
9 ? erased.
Put a line break.
Q Delete
If the cursor is at the
right end of a line,
this erases text one
character at a time.
• You can also delete
text by pressing 6
on the remote control
unit.
9
Clear
10
11