Advertisement
Brought to You by www.snapwhole.com
NOTE: We recommend the use of in-line filter, regulator, and oiler in any
compressed air system using tools purchased from Harbor Freight Tools. Please
refer to the schematic below for a suggested system set up. These components
are not included in this kit, but are available from Harbor Freight Tools.
Pneumatic
Tool
Note: Performance of these tools may vary depending on variations in local air pressure.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
1.
Install one of the Standard 1/4" Male Fittings to the Air Inlet of each tool. First
wrap the threaded portion of the Fitting with pipe thread seal tape before
threading it into the Air Inlet. Tighten securely.
2.
Attach a standard quick connector (not included) to your air pressure source
hose. Then attach the air hose to the Tool.
NOTE: If you are not using an automatic in-line oiler, add a few drops of pneumatic
oil to the Air Inlet before attaching the air hose. Add a few more drops of oil
after every hour of continual use.
3.
Set the air pressure regulator at 90 psi.
WARNING: DO NOT INCREASE THE AIR PRESSURE to the tool beyond 90
PSI. This may damage the tool, or cause personal injury.
4.
Check the air line and its connections for air leaks. Make note of these, and
repair them before using this tool.
CAUTION: Turn off your air compressor and disconnect the air pressure hose
before changing attachments or making any adjustments to these tools. Severe
injury or property damage may otherwise result.
SKU 46446
For technical questions and replacement parts, please call 1-800-444-3353
Operation
Direction Controller (25)
Page 6
Advertisement
