Advertisement
Brought to You by www.snapwhole.com
NOTE: Part numbers in this section refer
to the Parts List on page18 and the
Assembly Drawing on page 19.
Attaching or Removing the Pad
1.
Disconnect the tool from its power
source before attaching or removing
the Pad (44c).
2.
Rest the tool on a flat surface.
Thread the Pad into the Drive
Spindle (38c) until it is tight.
3.
Place a 6" diameter pad of adhesive backed sandpaper (not included) onto the
pad. Press it firmly into place.
4.
To remove the sandpaper, peel it from the Pad (44c). You may need to use a
scraping tool to completely remove it.
5.
To remove the Pad from the tool, place the Spindle Lock (41c) vertical on the
groove of the Drive Spindle (38c) to hold it in place. Rotate the Pad (44c)
counterclockwise to remove it from the tool.
To Adjust the Sander for Circular or Orbital Motion
1.
The sander may be adjusted for circular or orbital motion. In circular motion, the
sanding pad spins around its center. In orbital motion, in addition to spinning
around its center, the entire pad rotates around the axis of the tool spindle.
2.
To adjust the sander for
circular motion, position the
round edge of the Orbital Hub
(41c) against the round edge
of the Drive Spindle (38c). To
adjust the Sander to move in
an orbital motion, position the
flat edge of the Orbital Hub
(41c) against the round edge
of the Drive Spindle (38c).
Please see the photo.
SKU 46446
For technical questions and replacement parts, please call 1-800-444-3353
6" Dual Action Air Sander
OPERATION
(41c)
(38c)
Page 16
Advertisement
