Advertisement
Brought to You by www.snapwhole.com
5.
Use the right tool for the job. Do not attempt to force a small tool or
attachment to do the work of a larger industrial tool. There are certain
applications for which this tool was designed. It will do the job better
and more safely at the rate for which it was intended. Do not modify this
tool and do not use this tool for a purpose for which it was not intended.
6.
Dress properly while working. Protect your skin from accidental abrasion
burns by wearing tough long sleeves and safety gloves. Do not wear loose
clothing or jewelry as they can be caught in moving parts. Protective,
electrically non-conductive clothes and non-skid footwear are recommended
when working. Wear restrictive hair covering to contain long hair.
7.
Use eye and ear protection. Always wear ANSI approved impact safety
goggles and full face shield when using this tool. Wear an ANSI approved dust
mask or respirator when working around metal, wood, and chemical dusts and mists.
8.
Do not overreach. Keep proper footing and balance at all times. Do not
reach over or across running machines.
9.
Maintain tools with care. Keep tools clean and in good condition for better
and safer performance. Follow instructions for lubricating and changing
accessories. Inspect tool fittings and hoses periodically and, if damaged, have
them repaired by an authorized technician. The handles must be kept clean,
dry, and free from oil and grease at all times.
10. Disconnect power. Disconnect from air pressure source when not in use.
11. Remove adjusting keys and wrenches. Check that keys and adjusting
wrenches are removed from the tool or machine work surface before connecting it.
12. Avoid unintentional starting. Be sure the throttle lever is in the Off position
when not in use and before attaching to pressure source. Do not carry any
tool with your hand on the throttle lever, whether it is attached or not.
Disconnect the air hose from the tool when not in use.
13. Stay alert. Watch what you are doing, use common sense. Do not operate
any tool when you are tired.
14. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment and binding
of moving parts; any broken parts or mounting fixtures; and any other
condition that may affect proper operation. Any part that is damaged should
be properly repaired or replaced by a qualified technician. Do not use the tool
if the throttle lever does not function properly.
SKU 46446
For technical questions and replacement parts, please call 1-800-444-3353
Page 4
Advertisement
