Keypad: Names And Functions - YASKAWA HV600 Series Installation & Primary Operation

8 Keypad: Names and Functions

8 Keypad: Names and Functions
No. Name
AUTO LED
A
ALM LED
B
C microSD Card Insertion Slot
Function Keys
(F1, F2, F3)
D
HAND LED
E
HAND Key
F
OFF Key
G
48
Figure 8.1 Keypad
Table 8.1 Keypad: Names and Functions
*1
Illuminates to show that the drive is in AUTO Mode.
Illuminates when the drive detects a fault.
Flashes when the drive detects:
• An alarm
• An oPE parameter setting error
• A fault or alarm during Auto-Tuning
The LED turns off when there are no drive faults or alarms.
The insertion point for a microSD card.
The menu shown on the keypad sets the functions for function keys.
The name of each function is in the lower half of the display window.
*1
Illuminates to show that the drive is in HAND Mode.
Sets drive operation to HAND Mode.
The drive uses the S5-01 [HAND Frequency Reference Selection] setting.
Stops drive operation.
Note:
The OFF key has highest priority. Push
command source. Set o2-02 = 0 [STOP Key Function Selection = Disabled] to disable
Function
to stop the motor even when a Run command is active at an external Run
YASKAWA TOEPC71061732E HV600 Drive Installation & Primary Operation
priority.