Finisher (For Mx-M850) / Saddle Stitch Finisher - Sharp MX-M1100 Maintenance Manual

FINISHER (FOR MX-M850) / SADDLE STITCH FINISHER

1
Open the cover.
2
Pull out the unit.
3
Remove the staple case.
Staple section
Saddle stitch section
(1)
(2)
In the saddle stitch section, replace the cartridges in
the front and back staple cases (two cartridges).
Slowly pull out the unit until it
stops.
Grasp the green part of the
staple case and pull the staple
case down.
(1) Grasp the green part and
pull it forward and down.
The unit that holds the
staple case will move
forward.
(2) Pull the staple case up
and out.
REPLACING THE STAPLE CARTRIDGE
4
Release the staple case cover lock.
When staples remain, the lock cannot be released.
5
Remove the staple cartridge.
6
Install a new staple cartridge.
Do not remove the seal from the cartridge before
inserting the cartridge into the case.
While holding both sides of the
staple case, pull up the upper
unit.
Push the staple case in until it
clicks into place.
13