Using The Wall Bracket - Kompernass WK 8 B3 Operating Instructions Manual

Using the wall bracket

You can mount the camera permanently on a wall or ceiling using
the supplied wall bracket. Before mounting the wall bracket you
should ensure that all screws are tight.
ATTENTION
► Ensure that there are no electric lines, water or heating pipes
installed at the proposed drilling location!
► The supplied anchors are only suitable for mounting on
concrete or stone. Before starting the installation, please check
your installation location carefully for its suitability for the an-
chors. The assembly material must be suitable for the respective
location. If in doubt, consult a professional.
NOTICE
► During assembly, make sure that you do not mount the camera
upside down. Photos and videos cannot be rotated later.
♦ Mark the drill holes d by holding the foot of the wall bracket at
the desired mounting location and marking the hole positions.
♦ Use a drill with a 6 mm drill bit to drill the required holes and
insert the plugs and insert the anchors h flush with the wall.
♦ Screw the wall bracket to the wall using the supplied screws g.
♦ Mount the camera with the tripod socket i on the tripod screw o
and screw the camera on a little way (about three turns).
♦ Turn the camera in the desired direction and lock it with the lock-
ing washer a.
♦ To bring the camera into its final position, loosen the two hex
screws s a little with the hex key f. Align the camera and fix it
in position with the hex key by tightening the two hex screws.
WK 8 B3
GB │ IE │ 35 ■