Kompernass WK 8 B3 Operating Instructions Manual page 31

Note when setting up the camera that you need at least five photos to
create a video. The recording time set in the menu "Target recording
time" also applies to the time lapse recording.
After you confirm "Single shot" or "Time lapse video" with the OK
button, you can set the desired shot lag in the on-screen menu that
now appears:
♦ Press the /
♦ Now switch to the next field, "Min", using the
/ buttons to set the minutes of the desired shot lag.
♦ Now switch to the next field, "Sec", using the
/ buttons to set the seconds of the desired shot lag.
Confirm your selection with the OK button. Afterwards, press the
♦
MENU button to close this sub-menu.
NOTICE
► When time-lapse recording is enabled, the motion sensor 5 is
disabled.
► For technical reasons, "Video" is automatically set in the "Mode"
menu as soon as the "Time lapse video" sub-menu is active.
WK 8 B3
Set time lapse
Hr
Notification: Motion
sensors deactivated
buttons to set the hour of the desired shot lag.
Sec
button. Press the
button. Press the
GB │ IE │ 27 ■