Kompernass WK 8 B3 Operating Instructions Manual page 34

♦ Repeat the steps described above to set all four characters.
Confirm your selection with the OK button. Afterwards, press the
♦
MENU button to close this sub-menu.
The selected number combination must now be entered every time
the camera is switched on before it can be operated.
If you enter the incorrect password five times in a row, the camera
will switch off. Switch the camera back on again for another five
attempts at entering the password.
If you forget the character combination, proceed as follows to unlock
the camera and to reset it to its factory default settings:
♦ Download the wildlife camera software from www.kompernass.com.
♦ Unzip the file and copy the file "Rom_CodeWK8B3.bin" onto a
blank memory card.
♦ Insert the memory card into the device while the mode selector
switch z is set to the OFF position.
♦ Keep the button pressed while moving the mode selector
switch to the TEST position. Keep the
until the display q shows the notification "Firmware upgrading...
Keep table".
♦ After around 20 seconds the camera switches off.
♦ Switch the camera back on by moving the mode selector switch
to the OFF position and then to the TEST position. The camera
can now be used without entering a password.
NOTICE
► This procedure will permanently delete any previously made
settings and return the device to the factory settings.
■ 30 │ GB │ IE
button pressed down
WK 8 B3