Mercedes-Benz E-Class Coupe 2021 Operator's Manual page 59

O Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
® When installing a LATCH-type (ISOFIX)
child restraint system, also observe the follow‐
ing:
O When using a baby car seat in weight
group 0/0+ and a rearward-facing child
restraint system in weight group I on a
rear seat: adjust the front seat so that the
seat does not touch the child restraint sys‐
tem.
O When using a forward-facing child
restraint system in weight group I: the
backrest of the child restraint system must
lie as flat as possible against the backrest of
the vehicle seat.
O You can have the head restraints of the rear
seats removed and installed at a qualified
specialist workshop. This may be necessary
for the use of certain child restraint sys‐
tems.
O If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys‐
tems in weight category II or III.
Contact with the roof when the head
restraint is fully extended and locked in
place will not result in any restrictions on
use.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be installed facing the
wrong direction. Where possible, adjust the
seat cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraint. Adjust
the head restraints as appropriate.
Occupant safety
1 LATCH-type (ISOFIX) mounting bracket
Before every journey, make sure that the LATCH-
type (ISOFIX) child restraint system is engaged
correctly in both mounting brackets in the vehi‐
cle.
Remove and store away covers 1.
#
57