DTX-MFM/SFM Fiber Modules
Users Manual
Fiber Test Settings
Table 2 describes the test settings that apply to fiber
cabling.
Setting
SETUP > Fiber >
Select a fiber type that is appropriate for the type you will test.
Fiber Type
SETUP > Fiber >
Select the appropriate test limit for the job. The tester compares the fiber test results to the
selected test limit to produce PASS or FAIL results.
Test Limit
SETUP > Fiber >
Use Smart Remote mode for testing dual-fiber cabling.
Remote End Setup
Use Loopback mode for testing patch cords and cable spools.
Use Far End Source mode with an optical source for testing individual fibers.
12
To access the fiber test settings turn the rotary switch to
SETUP; then select Fiber. Use
Table 2. Fiber Test Settings
Description
BC
to see different tabs.
-continued-