Paper Holder (Main) Assembly - Sony UP-DR200 Service Manual

1-6-3. Paper Holder (Main) Assembly

1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly/side panel (L)
assembly. (Refer to Section 1-4-2.)
3. Remove the paper door assembly.
(Refer to Section 1-6-2.)
4. Remove the paper guide roller.
5. Remove the two hooks, then remove the paper holder
(MB).
Paper guide roller
Hooks
Paper holder (MB) assembly
6. Remove the eight screws, then remove the four oil
damper.
7. Push the arm lock plate (L) subassembly and arm lock
plate (R) subassembly in the direction of the arrow,
then place the paper arm (L) subassembly and paper
arm (R) subassembly in the chassis.
n
If this is not performed, the paper holder may be
damaged when the paper holder (main) assembly is
removed.
8. Remove the three screws (BVTT3 x 6) and six screws
(BTP3 x 10), then pull out the paper holder (main)
assembly slowly while pushing the paper arm shaft in
the direction of the arrow.
m
. Be careful when removing the paper holder (main)
assembly to prevent the paper arm shaft from
coming off the paper holder assembly because it is
not fixed.
. When removing the paper holder (main) assembly,
make sure that the door lock cam position is as
shown in the illustration.
1-8
Arm lock plate (L)
subassembly
Oil damper
PS2 x 5
BTP
3 x 10
Paper arm (L)
subassembly
BVTT
3 x 6
BVTT
3 x 6
Paper holder (main)
assembly
Paper arm (R)
subassembly
X
9. Attach the paper holder (main) assembly in the reverse
order of steps 1 to 8.
Arm lock plate (R)
subassembly
Door lock cam
Oil damper
PS2 x 5
BTP
3 x 10
Chassis
Paper arm shaft
Paper arm shaft
Door lock cam
UP-DR200