Supply Drive Assembly - Sony UP-DR200 Service Manual

1-6-7. Supply Drive Assembly

1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly.
(Refer to Section 1-4-2.)
3. Remove the ribbon door assembly.
(Refer to Section 1-6-1.)
4. Remove the inner cover (front).
(Refer to step 8 in Section 1-6-1.)
5. Remove the cutter unit. (Refer to Section 1-6-5.)
6. Remove the three snap rings (E2.3), six bearing
flanges and three bearings (630), then remove the
brake link lever subassembly.
n
When attaching the bearing flange, be sure to attach it
being careful of the orientation.
7. Disconnect the two harnesses from the connectors
(CN241 and CN242) on the SU-138 board.
8. Disconnect the three harnesses from the connectors
(CN451 to CN453) on the SE-937 board.
9. Remove the hook, then remove the rail cover.
10. Remove the four screws, then remove the supply drive
assembly.
SE-937 board Side B
CN452
CN453
Hook
Rail cover
Bearing flanges
Bearing (630)
1-10
CN451
Harness
Supply drive
assembly
BVTT
3 x 6
Harness
CN241
Harness
SU-138 board
CN242
E2.3
*1
*1
*2
*1
E2.3
*1
*2
*2
*1
*1
E2.3
Brake link lever
subassembly
*1: Bearing flange
*2: Bearing (630)
11. Remove the two screws (BVTT3 x 6), then remove
the SE-937 board.
12. Remove the two screws (PS2.6 x 5), then remove the
DC motor (S) subassembly.
13. Remove the two solders, then remove the SU-138
board.
BVTT
3 x 6
PS2.6 x 5
14. Attach the supply drive assembly in the reverse order
of steps 1 to 13.
SE-937 board
Supply drive assembly
DC motor (S) subassembly
SU-138 board
Solders
UP-DR200