Changing The Print Cartridge; Attaching The Paper Holder - Sony UPX-C200 Operating Instructions Manual

2
Insert the print cartridge into the cartridge
compartment firmly until it clicks into place.
3
Close the cartridge compartment cover.

Changing the print cartridge

When the print cartridge runs out, the
and an error message appears on the operation display.
Replace the print cartridge.
1
Push on PUSH OPEN to open the cartridge
compartment cover.
2
Press up the cartridge release lever.
The cartridge pops out. Remove the cartridge.
3
Insert a new print cartridge, and close the cover.
Notes
• Never put your hand into the cartridge compartment.
The thermal head reaches high temperatures,
especially after repeated printing.
• Do not rewind the ink ribbon and use the rewound
print cartridge for printing. Otherwise, proper printing
result will not be obtained, or even a breakdown may
occur.
• If the print cartridge does not click into place, remove
it and then re-insert it. If the ink ribbon is too slack to
be loaded, wind the ink ribbon in the direction of the
arrow to remove the slack.
Print cartridge
• If the print cartridge is not loaded when you turn on
the printer, the
• Do not touch the ink ribbon or place the print cartridge
lamp lights
in a dusty location. Fingerprints or dust on the ink
ribbon may result in imperfect printing.
• Do not change the print cartridge while printing.
Notes on storing the print cartridge
• Avoid placing the print cartridge in a location subject
to high temperatures, high humidity, excessive dust or
direct sunlight.
• When you are going to store a partially used cartridge,
store it in its original bag.

Attaching the paper holder

Attach the supplied paper holder to the paper tray as
follows:
1
Cartridge release
lever
lamp lights up.
Insert the tips of both ends of the paper holder into
the holes located at the bottom of the paper tray,
pinching the portions near the two ends.
Paper tray
Paper holder
15
Preparations