Table of Contents
Advertisement
eee
Troubleshooting
Check the following to troubleshoot problems.
Please place Video Print Paper in tray.
» Make sure that print papers are inserted in the paper
tray.
» Make sure that the paper tray is inserted firmly into
place.
Please insert Video Print Cartridge.
* Make sure that the print cartridge is inserted.
Please remove jammed paper from rear of unit.
» Remove the jammed print paper from the rear of the
unit.
Please open paper tray and remove jammed
paper.
» Remove the paper tray and remove the jammed print
paper.
Out of ink ribbon. insert new cartridge.
» The ink ribbon has been completely used up. Replace
the print cartridge with a new one.
Print paper and ink ribbon are mismatched.
» Use the print cartridge and the print paper supplied in
the same carton.
Please remove printed paper.
» Too many prints are left on the paper outlet. Remove
the prints.
Please wait while printer resets itself.
* The temperature inside the printer is not suitable for
printing. Wait until the unit starts printing again
automatically.
If the printer does not start printing even when the
message disappears, press the PRINT.
Cannot print images. See instruction manual.
» Make sure that the camcorder starts playback.
» If you use the @LANC cable to connect the printer,
make sure that the @LANC cable is connected
correctly and securely. If you use the VCR with the
€LANC M/S
mode switch, set to the "S" position.
For Your Information
If the print paper jams, the error message appears on the
screen and printing stops. Remove the jammed paper
according to the following procedures.
if the error message "Please remove jammed
paper from rear of unit." appears on the TV
screen
Remove the jammed paper from the rear of the unit.
Remove the jammed paper.
If the error message "Please open paper tray
and remove jammed paper."
Remove the paper tray and remove the jammed paper.
Then make sure that the print papers are set in the tray
properly and reinsert the tray.
t
SF bee SI
Remove the jammed paper.
Note
If the error message stil] appears on the TV screen after having
removed the jammed paper, turn the power off and on again.
In this case, the stored picture and various settings in memory
will be canceled.
Advertisement
Table of Contents
