Land Pride RCR1860 Operator's Manual page 34

Section 5: Maintenance &Lubrication
Lubrication Points
Lubrication
Legend
Do Not Overfill
IMPORTANT: This implement is shipped with a vented
dipstick packaged in the Operator's Manual bag and
should have been installed in the gearbox by your
dealer. Please consult your dealer if vented dipstick
was not included.
IMPORTANT: Use a suction or siphon pump to drain
gearbox of oil when there is not an oil drain plug.
30
RCR1860 & RCR1872 Rotary Cutters 312-849M
Table of Contents
Multi-purpose
spray lube
35894
35894
30215
Multi-purpose Multi-purpose
grease lube oil lube
Gauge Wheel Spindle Tube
Type of Lubrication: Grease
Quantity = 6 pumps
Gauge Wheel Hub
The gauge wheel hub is equipped with a relief hole
located directly opposite the grease fitting. The relief
hole releases pressure from inside the hub casting
when it is greased. The hub should be greased until
grease purges from the relief hole.
Type of Lubrication: Multi-purpose Grease
Quantity = Until grease purges from the relief hole
Gearbox
NOTE: Do not overfill! Cutter should be level when
checking oil. Oil expands when hot, therefore,
always check oil level when cold.
Method 1: Unscrew top vented dipstick (#1). Wipe oil
from dipstick and screw dipstick in without tightening.
Unscrew dipstick and check oil on dipstick. If below
bottom level mark, add recommended gear lube through
dipstick hole until oil reaches top mark on dipstick.
Reinstall vented dipstick and tighten.
Method 2: Remove side oil plug (#2). If oil is below
bottom of plug hole, add recommended gear lube
through top dipstick hole until oil flows out of side plug
hole. Reinstall and tighten side oil plug (#2) and vented
dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out side plug hole in gearbox.
50
Intervals in hours at which
lubrication is required
Hrs
24
Hours
8
Hours
8
Hours
10/23/20