Land Pride RCR1860 Operator's Manual page 17

Section 1: Assembly & Set-Up
6. Snap ring (#7) is shipped stored on clevis pin (#19).
Remove hairpin cotter (#17), clevis pin (#19), and
snap ring (#7).
7. Reattach clevis pin (#19) to A-frames (#3) with
hairpin cotter (#17). Keep snap ring (#7) for driveline
assembly.
8. The front A-frame brace bars (#3) are shipped
attached to lower holes "A" . Remove hex nylock nuts
(#22), flat washers (#15) and bolts (#8A).
9. Reattach front A-frame brace bars (#3) to holes "B"
with 5/8"-11 x 2" hex head bolts (#8A), bushings (#5),
flat washers (#15), and hex nylock nuts (#22).
Tighten nylock nuts (#22) to the required torque.
IMPORTANT: See Detail A in Figure 1-2 on page 13.
Floating top hitch (#20) must be installed with
ears (#21) above rear brace bars (#4).
10. Rotate A-frame/floating top hitch (#3 & #20) up and
rotate left rear brace (#4) up until holes in rear
braces (#4) align with hole in floating top hitch (#20).
11. Insert 3/4"-10 x 4" GR5 bolt (#9) into the left rear
brace (#4), floating top hitch (#20), and right rear
brace (#4).
10/23/20
Table of Contents
Tailwheel & Hitch Assembly
Figure 1-2
12. Secure bolt with hex flange locknut (#12). Draw
locknut (#12) up snug and then back off 1/4 turn.
13. Install one machine washer (#16) on pivot shaft of
tailwheel (#6).
14. Insert tailwheel pivot shaft (#6) into tailwheel
A-frame (#1).
15. Install second machine washer (#16) on pivot shaft of
tailwheel (#6) and secure with roll pin (#18).
NOTE: After assembly of hitch and tailwheel, push
on top of A-frame assembly (#3). It should rotate
backward and floating top link (#20) should rotate
upward. If they are too stiff to rotate, loosen
nuts (#12) until they will rotate freely.
RCR1860 & RCR1872 Rotary Cutters 312-849M
21407
13