Land Pride RCR1860 Operator's Manual page 33

Section 5: Maintenance &Lubrication
Long-Term Storage
Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help ensure the unit is ready
for field use the next time you hook-up to it.
!
DANGER
To avoid serious injury or death:
•
Always disconnect driveline from power take-off shaft
before servicing drivetrain and cutter blades. The power
take-off can be engaged if tractor is started.
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
Long Term Storage Continued
1. Clean off any dirt and grease that may have
accumulated on the cutter and moving parts. Scrape
off compacted dirt from the bottom of deck and then
wash surface thoroughly with a garden hose. A
coating of oil may also be applied to the lower deck
area to minimize oxidation.
2. Check blades and blade bolts for wear and replace if
necessary. See "Cutter Blade Maintenance" on
page 26.
3. Inspect cutter for loose, damaged, or worn parts and
adjust or replace as needed.
4. Repaint parts where paint is worn or scratched to
prevent rust. Ask your Land Pride dealer for aerosol
touch-up paint. Paint is also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the Aerosol part number
.
Land Pride Aerosol Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE SPRAY CAN
821-054C PAINT MEDIUM RED SPRAY CAN
821-058C PAINT GREEN SPRAY CAN
821-066C PAINT ORANGE SPRAY CAN
821-070C PAINT GP GLOSS BLACK SPRAY CAN
5. Replace all damaged or missing decals.
6. Lubricate as noted under "Lubrication Points"
starting on page 30.
7. Store cutter on a level surface in a clean, dry place.
Inside storage will reduce maintenance and make for
a longer cutter life.
8. Follow all unhooking instructions on page 24 when
disconnecting tractor from cutter.
10/23/20
Table of Contents
Ordering Replacement Parts
Land Pride offers equipment in factory standard beige
color with black highlights. Equipment in special colors
may be purchased in green, red or orange. Because of
the variety of colors available, special attention must be
given to the part number to prevent ordering the wrong
replacement part. A suffix number corresponding to one
of the colors below must be added at the end of Land
Pride's part number when ordering a replacement part
with that color. Parts ordered without a suffix number will
be supplied in factory standard colors.
81 . . . . . . Green
82 . . . . . . Orange
83 . . . . . . Red
For example, if you are ordering a replacement part with
part number 555-555C and the existing part is red, then
add the suffix 83 to the end of the number to make the
part number read 555-555C83.
84 . . . . . . . Blue
85 . . . . . . . Black
RCR1860 & RCR1872 Rotary Cutters 312-849M
29