Supported Devices - Hitachi X200 Series Connection Manual

6

Supported Devices

The following table shows the range of supported device addresses. Please note that the actually supported range
of the devices varies depending on the External Device to be used. Please check the actual range in the manual of
your External Device.
Enter the External Device address in the dialog below.
1. Address
2. Reference
• If you select the [Set as Default Value] option, the set value for a new address entry will be
6.1 X200 series
Device
Coil
Holding register
*1 Specify only the word address whose last digit is "1" .
• Holding register number 0900h is an address for the command (enter command) to write in
• You can only set the Read Area Size for the system area available to use in the External
• Refer to the precautions on manual notation for icons in the table.
GP-Pro EX Device/PLC Connection Manual
2
Enter the address.
Available parameter list is displayed.
Click the parameter to use and press "Select", then the address is entered.
displayed as the default value.
Bit Address
00001 - 0001F
-
nonvolatile memory. By writing "1" in 0900h, writing to nonvolatile memory is enabled.
Device. Please refer to the GP Pro-EX Reference Manual for Read Area Size.
Cf. GP Pro-EX Reference Manual "LS Area (Direct Access Method Area)"
"Manual Symbols and Terminology"
1
This address can be specified as system data area.
Word Address
00001
40001 - 41544
41
Inverter MODBUS RTU Driver
32bits Notes
*1