Sending A Priority Fax; Receiving A Fax; Changing The Receive Modes; Receiving Manually In Telephone Mode - Samsung CLX-8385NX Series User Manual

• If you do not enter Job Name, the machine assigns the job name
as 'Fax Send Job xxx'. 'xxx' number are set in order.
Note
Start Time is the specific time you want the fax to be sent. You
can set Start Time on a 24 hour basis and 15 minutes later than
the current time. For example, if it is 1:00, then you can set the
time starting from 1:15. If the set time is incorrect, the warning
message will appear and the machine resets it to the current
time.
Press OK to start storing the scanned original data into memory.
7
Note
To cancel delaying a fax, press Off before sending is activated.

Sending a priority fax

This function is used when a high priority fax need to be sent ahead of
reserved operations. The original is scanned into memory and
immediately transmitted when the current operation is finished. In
addition, priority transmission will interrupt a sending to multiple
destinations between stations (example, when the transmission to station
A ends, before transmission to station B begins) or between redial
attempts.
Press Fax from the Main screen.
1
Place the originals face up in the DADF.
2
Adjust the document settings in the Image tab and the Basic tab.
3
Press the Advanced tab > Priority Send.
4
Press On.
5
Press OK.
6
Press Start to start the urgent fax job.
7

Receiving a fax

This section explains how to receive a fax, and the special receiving
methods available.

Changing the receive modes

Your machine is preset to Fax mode at the factory. When you receive a
fax, the machine answers the call on a specified number of rings and
automatically receives the fax. But if you want to change the Fax mode
to another mode, refer to next steps.
Press Machine Setup on the control panel.
1
Select Admin Setting. When the login message pops up, then
2
enter password and press OK. (Page 3.5)
Press the Setup tab > Fax Setup > Fax Initial Setup > Receive
3
Mode.
Select the option.
4
• Telephone: Receives a fax by pressing On Hook Dial and then
Start.
• Fax: Answers an incoming fax call and immediately goes into the
fax reception mode.
• Answering Machine/Fax: Is for when an answering machine
attached to your machine. Your machine answers an incoming call,
and the caller can leave a message on the answering machine. If
the fax machine senses a fax tone on the line, the machine
automatically switches to Fax mode to receive the fax.
Press OK.
5
Note
When the memory is full, the machine can no longer receive any
incoming fax. Secure free memory to resume by removing data
stored in the memory.

Receiving manually in Telephone mode

You can receive a fax call by pressing On Hook Dial and then pressing
Start when you hear a fax tone from the remote machine. The machine
begins receiving a fax.
Receiving automatically in Answering Machine/
Fax mode
To use this mode, you must attache an answering machine to the EXT
socket on the back of your machine. (Page 1.4)
If the caller leaves a message, the answering machine stores the
message as it would normally. If your machine detects a fax tone on the
line, it automatically starts to receive the fax.
6.5
<Faxing (Optional)>