Loading Media For Peel Configuration - Brady 1024 User Manual

1.7

Loading Media for Peel Configuration

1. Open the Printer's Top Cover.
2. Release the Printhead Carrier Assembly by pushing the Printhead
Latch. Raise the Assembly to its up position.
3. Place a roll of the chosen media on the Media Hub and place it in the
Printer. Ensure that the Media Hub is flush against the media.
4. Move the Peel Off Lever forward to its open position.
5. Peel off eight inches of labels. Route the backing over the Tearbar
and behind the Peel Off Shaft as shown below:
Figure 1-7 Peel Off Media Loading
6. Slide the Media Guide over until it is against the side of the media.
7. Move the Peel Off Lever back to its closed position.
8. Close the Printhead Carrier Assembly, press down until it latches.
9. Close the Top Cover. Press the Feed Button several times to ensure
proper tracking. The labels should separate as the Printer feeds.
8 Getting Started