Brady 1024 User Manual page 27

A STX L Command switches the Printer from the System Level to the
Label-Formatting Mode. All command characters after STX L are
interpreted as Label Formatting Commands until the Label Formatting
mode is terminated with the command character E. All Label Formatting
Commands are terminated with hex value 0D.
CC Description
: Set cut by amount (4 digits)
The cutter function will perform a cutting
action after the number of labels specified.
A Set format attribute
C Set column offset amount
c Set cut by amount (2 digits)
D Set height and width dot size
E Terminate field generation and print label
G Place data in global register
H Enter heat setting
(The amount of heat applied per dot row, can
be used to help control print quality)
m Set metric mode
M Set mirror image mode
('Mirror Images' current formatted label)
P Print speed
p Set label backup speed
Q Enter quantity of labels to print
R Set row offset amount
r Recall stored label format
S Slew (feed) speed
s Store label format in module
T Set field data line terminator
U Make previous field a string replace field
Table 2-4 Label-Formatting Commands
Printing Labels
Format
:nnnn
nnnn = 4 digits of labels printed
before cut. Default = 0001
An n=1-XOR, 2-Transparent, 3-
Opaque, 5-Inverse
Cnnnn nnnn= in/100 or mm/10
cnn nn = 2 cut amount
h = Horiz. dot size; can be 1 or 2
v = Vert. dot size; can be 1,2, or 3
(0.005" steps) Default is "D22"
Hnn nn = 2 digits. 1 - 30
10 is nominal and default
The Printer must be reset in
order to return to standard
measure
'M' must be re-sent to cancel.
* Will not mirror polygons.
Px x x = A -C (1.0 to 2.0 ips)
px x x = A -C (1.0 to 2.0 ips)
Qnnnn nnnn = quantity
Rnnnn nnnn = in/100 or mm/10
rnn...n nn...n Label name of up
to 16 char. terminated by CR.
Sx x x = A -C (1.0 to 2.0 ips)
sann...n a - destination module
A Memory Module A
nn...n - label name (16 char.
max)
Tnn nn = 2 digit ASCII Hex
00 - FF
21