Installing The Dvd Player - Samsung HT-TX500 Instruction Manual

Installing the DVD player

STAND
1
STAND BASE
2
STAND
3
4
14
1
Mount the stand on the stand base and tighten 4
screws on the bottom side of the stand base.
2
Secure the main unit by aligning 2 protruding points
on the back of the main unit with the fixing holes
on the stand.
3
Tighten 3 screws in the middle of the stand.
4
Push the cable into the cable fixing hole in the stand.
5
5
Open the holder cover of the round board on the
bottom of the stand and pass the cables through the
holder.
6
Squeeze the cables into the groove on the holder of
the round board.
6
Round Table
Holder
7
Close the holder cover.
7
8
Open a Toroidal Ferrite Core by pulling it upward.
Wrap it around of the system connection cable so it
8
will be next to the DVD Player. Close it back by
pressing it all the way down until you hear a clicking
sound.
• For the stand packages, refer to page 9.
• The Toroidal Ferrite Core is designed to reduce electromagnetic waves that may cause interference.
GB
15