Speaker Installation; Installing The Dvd Player - Samsung HT-TXQ120K Instruction Manual

Speaker Installation

How to Install the Speaker and the Stand
2
1
STAND
BASE
STAND
4
3
6
5
Speaker Packages
Please confi rm that all the following contents are included in the package.
STAND BASE
SPEAKER STAND Screw Screw
Front/Rear Speaker (4EA)
* Front speakers and rear speakers are packaged
separately as shown in the diagram.
12
1
Turn the stand upside down and mount it on the
stand base.
2
Tighten 4 screws on the bottom side of the stand
base.
3
Place the stand on the floor and tighten 2 screws
on the back of the stand.
4
Mount the speaker on the stand.
SPEAKER
5
Tighten 2 screws on the back of the speaker.
6
STAND This is the successfully assembled speaker.
• Make sure that the speaker is installed on a flat and
stable area. Otherwise it may be easily knocked over.
Speaker Accessories
Center Speaker
Subwoofer Speaker Speaker Cable (5EA)

Installing the DVD player

STAND
1
STAND BASE
2 3
BACK
COVER
4 5
STAND
6 7
8
Toroidal
System connection
Ferrite Core cable - main unit
9 10
BACK COVER
11
SPEAKERS OUT
FRONT R CENTER FRONT L
ASC IN
REAR R REAR L
KARAOKE MIC RADIO ANT.
MIC 1 MIC 2
COMPONENT OUT
SYSTEM CONNECTOR WIRELESS
R L
AUX IN VIDEO OUT
System connection
cable - Main Unit to Subwoofer
1
Mount the stand on the stand base and tighten 4
screws on the bottom side of the stand base.
2
Loosen 2 screws at the bottom of the back cover.
3
Detach the back cover by lifting it up.
4
Secure the main unit by aligning 4 protruding points
on the back of the main unit with the fixing holes on
the stand.
5
Tighten 2 screws in the middle of the stand.
6
Open a Toroidal Ferrite Core by pulling it upward.
Wrap it around the top of the system connection
cable so it will be next to the DVD Player. Close it
back by pressing it all the way down until you hear a
clicking sound.
7
Push the cable into the cable fixing hole in the
stand.
8
To fix the cable, insert the cable holder into the hole
on the stand.
9
Let the cable run through the hole at the bottom of
the back cover and close the back cover.
10
Tighten 2 screws at the bottom of the back cover.
11
Open another Toroidal Ferrite Core by pulling
it upward. Wrap it around the other end of the
system connection cable so it is next to the
subwoofer. Close it back by way down until you
hear a clicking sound.
The Toroidal Ferrite Core is designed to
•
reduce electromagnetic waves that may cause
interference.
Stand Packages
Please confi rm that all the following contents are included in
the package.
STAND BASE
BACK COVER
Screw (6EA)
STAND
Holder Cable (3EA)
GB
13