Installing The Dvd Player - Samsung HT-P1200 Instruction Manual

Installing the DVD player

Combine the round board
1
and the stand with the
screws (4).
Insert two screws in the top
2
holes, but only screw them in
1/2 way.
Align the stand with the two
3
screws.
Fully tighten the screws to
4
secure the stand to the DVD
player.
Insert the remaining four
5
screws & tighten.
Caution
• Keep the main unit and speakers out of the reach of children as the
equipment could tip over.
11
Stand
Round Board
Tidying Cables Up
Push the cables connected to the
1
HDMI OUT, Component OUT, Video
OUT ports into the groove shown
in figure 1 using the Wire Hanger.
Push the cables connected to the
2
Audio IN, Anynet IN/OUT, Optical
Digital Audio IN and Audio OUT ports
into the groove shown in figure 2.
Open the holder cover of the round
3
board on the bottom of the stand and
pass the cables through the holder.
4
Squeeze the cables into the groove on
the holder of the round board.
5
Close the holder cover.
GB
Wire Hanger
1
Rear Side of
the Main Unit
2
Round Board Holder
12