24 Small form factor pluggable transceivers
Model and connector
100BASE-FX (LC)
T1 (RJ-48C)
For specifications for these SFPs, see
Job aid: SFP models with DDI support
Any Digital Diagnostic Indicating (DDI) SFP can be used in any Ethernet
Routing Switch 4500 that supports SFPs beginning with Release 5.2. The
optical functions of the SFP are supported. Access to the DDI information
will be provided in a future release.
The following table lists and describes the Nortel SFP models with DDI
capability.
Table 3
SFP models with DDI capability
Model
1000BASE-T (RJ-45)
1000BASE-SX
1000BASE-LX
1000BASE-BX (LC type)
For specifications for these SFPs, see
Installing an SFP
Install an SFP to provide an interface between the switch and the network
cable.
Installing an SFP takes about three minutes.
For translations of the following messages, see
and information" (page
Copyright © 2007-2008 Nortel Networks
.
Product number
AA1419074-E6
AA1419075-E6
Product number
AA1419043-E6
AA1419048-E6
AA1419049-E6
AA1419069-E6,
AA1419070-E6
16).
Nortel Ethernet Routing Switch 4500 Series
Installation — SFPs and XFPs
NN47205-301 02.01
20 October 2008
Description
1310 nanometers (nm), up to 2 km
Supported by the 4526FX, 4526T,
4526T-PWR, 4550T, 4550T-PWR
and 4524GT
1.544 Mbit/s Fast Ethernet to T1
remote bridge. Supported by the
4526FX, 4526T, 4526T-PWR,
4550T, 4550T-PWR and 4524GT
"SFP specifications" (page
Description
CAT5 UTP, up to 100 m. Note that
because the 1000BASE-T device is
all electrical, there is no need for DDI
support.
850 nm, up to 275 or 550 m
1310 nm, up to 10 km
Bidirectional 1310 nm and 1490 nm, up
to 10 km
"SFP specifications" (page
"Product safety warnings
35).
35).