Procedure Job Aid: Chassis Weight Including Components; Mounting The Ethernet Routing Switch 8310 And 8306 Chassis In An Equipment Rack - Nortel Passport 8306 Installation Manual

36 Ethernet Routing Switch 8310 and 8306 chassis installation
Prerequisites
•
•
Procedure steps
Step
1
2
3

Procedure job aid: Chassis weight including components

The following table shows the weight of each chassis including the
components.
Chassis
8310
8306
Mounting the Ethernet Routing Switch 8310 and 8306 chassis in
an equipment rack
Install the Ethernet Routing Switch 8310 and 8306 chassis in a standard
19-inch equipment rack to provide a convenient location for the safe
operation of the switch.
ATTENTION
If you are mounting the chassis in a 23-inch equipment rack, see the rack
manufacturer's 23-inch-to-19-inch rack adapter installation instructions.
Copyright © 2008 Nortel Networks
.
Provide adequate space around the unit for access to cable
connectors.
Ensure that the surface can safely support the weight of the chassis,
its components, and its attached cables. See
requirements" (page
Action
Set the switch on the flat surface and check for proper
ventilation.
Allow at least 2 inches 5.1 cm) on each side for proper
ventilation and 5 inches (12.7 cm) at the front for power cord
clearance.
Attach rubber feet to each marked location on the bottom of the
chassis.
The rubber feet are optional but recommended to keep the unit
from slipping.
Attach all devices to the ports.
Maximum weight (chassis and components)
225 pounds (lb) (102 kilograms [kg])
140 lb (63 kg)
Nortel Ethernet Routing Switch 8300
Installation — Chassis
NN46200-309 01.01 Standard
16 June 2008
35).
--End--
"Chassis installation time