Batch Batch Mode Operation; The Help Option; Pa Specify Part Type; Po Specify Port Name - Xilinx EZTag User Manual

Commands and options are not case-sensitive.

–batch Batch Mode Operation

Syntax
Abbreviation
The Batch option executes commands in batch mode. The bat_file
must have a ".cmd" extension and contain valid EZTag commands,
including interactive commands. You can add comments to files by
using the # symbol, either on the command line or on a new line.
–h The Help Option
Syntax
Abbreviation
The Help option displays command line usage information.

–pa Specify Part Type

Syntax
Abbreviation
The Specify Part Type option defines the part to be used such as
XC95108 and XC95216. This option is always required and specifies
the number, type, name and order of devices in the boundary-scan
chain. The parts are specified in order from the closest to TDI to the
closest TDO.

–po Specify Port Name

Syntax
Abbreviation
The Specify Port Name option identifies the port connection for the
XChecker cable. If you do not specify this option, the default option
AUTO, searches for the cable connected to any port, parallel or serial.
Valid ports for supported platforms are listed in Table 4-1.
EZTag User Guide
–batch bat_file.cmd
b
–help
h
–part parttype:design_name
pa
–port portname
po
EZTag with Workstations
4-5