Table of Contents
Advertisement
Arrangement example: 3 collectors, on end, alternate connection
Flow connection piece
Sensor well
Roof hook installation in preparation of the rooftop installation
Fitting roof hooks to battens
(pre-assembled)
M8x20 coach bolt
Fitting roof hooks to rafters
(refit)
Initially tighten the roof hooks
only by hand, as shown in the
diagram.
8
5. General preparations
Compensators
Grub screws M8x30 at the
bottom of the collectors
When fitting the connection pieces, compensators and plugs, always
counterhold the union nut on the collector.
Remove the sensor well from the control unit carton and insert into the flow
connector. Respectively insert 2 M8x30 grub screws fully into the lower tray
edge.
Top roof hooks
M8x20 coach bolt
Top roof hooks
When supporting the collectors on supports on pitched roofs, an installation
on battens is compulsory.
Are all gaskets in place?
Short leg
on top
Washer nut
M8
M8x20 coach bolt
Long leg
on top
1 x plug opposite
the connection
pieces
Return connector
(compulsory for
roof integration)
Bottom roof hooks
Washer nut M8
Bottom roof hooks
3062815_0110
Advertisement
Table of Contents
