Table of Contents
Advertisement
Collector installation
Combination screw
M8x20
Bottom mounting rail
Flashing tape
Washer
nut M8
Timber spacer
(batten height less 9 mm)
20
13. Roof integration, interlocking tile
Top mounting rail
8 x 80
1. Insert the collector with the grub screws first into the lower mounting rail
according to the diagram and initially secure by hand with the M8 nut with
washer.
2. Insert additional collectors likewise into the lower mounting rail.
3. Position the timber spacers (batten height) onto the rafters at the top of the
collectors. Position the mounting rail on top of the timber spacers and push
against the top of the collector. Initially secure the mounting rail with the
combination screws M8x20 and washers by hand to the collectors.
4. Drill a Ø 5 mm hole through the mounting rail and the wood spacers into the
rafter and secure to the rafter with hexagon head cap wood screw 8x80.
5. Secure the fittings for the flow and return. Check gaskets.
6. Check for leaks in accordance with the section "Leak testing"
Top mounting rail
Timber spacer
(batten height)
NB
- Are all gaskets in place?
- Maintain the necessary clearance
- Align all threaded fittings
- Counterhold with a second open-ended
spanner (max. torque 20 Nm.)
3062815_0110
Advertisement
Table of Contents
