2.1
Front Panel LEDs
The LED indicators on the front panel indicate the router functional status of the Prestige. The following
table describes the LED functions:
Field
PWR
SYS
LAN
10M
100M
Hardware Installation and Setup
Hardware Installation & Initial Setup
This chapter shows you how to make the cable connections to your Prestige as
Figure 2-1 Front Panel
Table 2-1 LED Functions
Description
The PWR (power) LED is on when power is applied to the Prestige.
The SYS (System) LED is on when the system is running normally, and off when the
system is not ready or failed. It flashes when the system is rebooting.
This green LED is on when the 10M Ethernet is connected and ready and off when
the 10M Ethernet is not ready or failed. This LED flashes when the Prestige is
sending or receiving packets.
This orange LED is on when the 100M Ethernet is connected and ready and off
when the 100M Ethernet is not ready or failed. This LED flashes when the Prestige
is sending or receiving packets.
Prestige 480 Dual BRI ISDN Router
well as set up your ISDN connection using the SMT.
Chapter 2
2-1