ZyXEL Communications Omni 288S User Manual page 73

Command
+FRQ=pgl, cbl
+FRY=n
+FSP=n
Class 2.0 Command Responses
Response
+FCI:"CSI ID string"
+FCO
+FCS: vr, br, wd, ln,
df, ec, bf, st
+FET:<ppm>
+FHS:<hsc>
Chapter 9 - Fax Operation
Value Description
Quality thresholds parameters:
pgl= Specify the percentage of good lines (e.g. with
0-64 negotiated number of pixels) required for a
(HEX page considered acceptable. The percentage of
value) good lines would be computed by the equation:
100 x (<lc> - <bl>) / <lc>
lc: total line count as reported in the +FPS:
response.
bl: bad line count as reported in the +FPS:
response.
If the resulting value is less than the value in
<pgl>, the page is unacceptable.
cbl= Specify the maximum tolerable number of
0-FF consecutive bad lines. If this value is exceeded
(HEX for a given page, the DCE shall consider the
value) page unacceptable.
0-255 ECM retry value n=0-255, units of 4 retries.
Enable polling command:
n=0 Disable polling.
n=1 Enable polling.
Value Function and Description
Report remote ID response, Called Station ID
Fax connection established response.
negotiated session parameters (DCS frame
information) response. Refer to +FIS= comnd.
Post page message response:
ppm=0 Another page next, same document.
ppm=1 Another document next.
ppm=2 No more pages of documents.
ppm=3 Another page next, same document, procedure
interrupt requested.
ppm=4 Another document next, procedure interrupt
requested.
ppm=5 No more documents or pages, procedure
interrupt requested.
termination status:
hsc= Call placement and termination. Refer to TIA-
0-0F 592 for details.
hsc= Transmit phase A and miscellaneous errors.
10-1F Refer to TIA-592 for details.
9-11