ZyXEL Communications Omni 288S User Manual page 104

Command Options Function & Description
&R0
&R1 *
&Sn
&S0 *
&S1
&Tn
&T0
&T1
&T3
&T4
&T5
&T6
&T7
&T8
&Vn
&V0
&Vn
&V5
&Wn n=0-3
&Xn
&X0 *
&X1
&X2
&Yn
&Y0
&Y1 *
&Y2
&Z?
&Zn=s n=0-39
Chapter 11 - AT Command Set Summaries
CTS tracks RTS, response delay is set in S26
Ignore RTS, assumes RTS always ON
Data Set Ready (DSR) function selection.
DSR overridden, DSR always ON.
DSR according to CCITT (ITU-TSS). (See also S41.5,
S44.4)
Modem testing.
Terminate test in progress.
Initiate Analog Loop-back (ALB) test.
Initiate Local Digital Loop-back (LDL) test
Grant Remote Digital Loop-back request from remote
modem
Deny Remote Digital Loop-back request from remote
modem
Initiate Remote Digital Loop-back (RDL) test
Initiate Remote Digital Loop-back with self test
(RDL+ST)
Initiate Analog Loop-back with self test. (ALB+ST)
View profile settings.
View current active settings.
View the (n-1) user profile settings (n=1-4)
View factory default settings.
Write current settings to user profile n in non-volatile
RAM. (See also S35.6)
Synchronous mode timing (clock) source selection
Modem provides synchronous transmit clock signal
(Internal clock to pin 15 of EIA-232D)
Terminal provides synchronous transmit clock signal
(External clock from pin 24 of EIA-232D)
Received carrier provides synchronous transmit clock
signal (Remote or Slave clock to pin 15 of EIA-232D)
Break handling. Destructive Break clears the buffer.
Expedited Break is sent immediately to the remote
system. (For internal modem only.)
Destructive, expedited.
Nondestructive, expedited.
Nondestructive, unexpedited.
Display all the phone numbers stored in non-volatile
RAM.
Write phone number/s to NVRAM at location n (n=0-
39) use AT*Dn or ATS29=n to set the default dial
pointer.
11-6
Ref.
S21.3
S14.4-5
S28.2-3