ZyXEL Communications Omni 288S User Manual page 69

Command
+FREL=n
+FREV?
+FSPL=n
All other +F commands are not supported, but the modem will respond OK. In
many cases this means "don't care." See PN 2388 for command details.
Class 2 Command Responses
Response
+FCFR
+FCIG:"string"
+FCON
+FCSI:"string"
+FDCS:vr,br,wd,ln,
df,ec,bf,st
+FDIS:vr,br,wd,ln,
df,ec,bf,st
+FDTC:vr,br,wd,ln,
df,ec,bf,st
+FET:n
+FHNG:n
+FNSC:"HEX string"
Chapter 9 - Fax Operation
Value Description
n=1 Received page good.
n=2 Page bad; retrain requested.
n=3 Page good; retrain requested.
n=4 Page bad; procedure interrupt requested.
n=5 Page good; procedure interrupt requested.
Phase C received EOL alignment:
n=0 The EOL patterns are bit aligned as received.
n=1 The last received bits of EOL patterns are
byte aligned by the DCE, with necessary zero
fill bits inserted. Refer to TIA PN-2388 for
details.
Request the DCE revision identification.
"Enable polling" command:
n=0 Disable polling.
n=1 Enable polling.
Value Function and Description
Confirmation .
Report remote ID response CIG.
Facsimile connection response.
Report remote ID response CSI.
Report session parameters response; refer to
+FDCC=.... command.
Report session negotiation parameters
response; refer to +FDCC=.... command.
Report remote capabilities response; refer to
+FDCC=.... command.
Post page message response; refer to the
+FET=n command.
Call termination status response.
n=00 Normal and proper end of connection.
n=10 Transmit error on phase A hang up code.
n=20 Transmit error on phase B hang up code.
n=40 Transmit error on phase C hang up code.
n=50 Transmit error on phase D hang up code.
n=70 Receive error on phase B hang up code.
n=90 Receive error on phase C hang up code.
n=100 Receive error on phase D hang up code.
Report the non-standard facilities command frame.
9-7