ZyXEL Communications Omni 288S User Manual page 67

Command
+FCTCRTY=
<value>
+FDCC=vr,br,wd,ln,
df,ec,bf,st
+FDCS=vr,br,wd,ln,
df,ec,bf,st
+FDIS=vr,br,wd,ln,
df,ec,bf,st
Chapter 9 - Fax Operation
Value Description
0-255 ECM retry count; in Error Mode only:
The sender will try to send a partial page 4
times. <value>=0 to 255; units of 4 retries. If
the Continue To Correct (CTC) count is 0, it
will not make any further attempts.
DCE capabilities parameters.
vr=0 Vertical resolution: Normal; 98 lpi.
vr=1 Vertical resolution: Fine; 196 lpi.
br=0 Bit rate: 2400 bit/s; V.27ter.
br=1 Bit rate: 4800 bit/s; V.27ter.
br=2 Bit rate: 7200 bit/s; V.29 or V.17.
br=3 Bit rate: 9600 bit/s; V.29 or V.17.
br=4 Bit rate: 12000 bit/s; V.17.
br=5 Bit rate: 14400 bit/s; V.17.
wd=0 Page width: 1728 pixels in 215mm.
wd=1 Page width: 2048 pixels in 255mm.
wd=2 Page width: 2432 pixels in 303mm.
ln=0 Page length: A4; 297mm.
ln=1 Page length: B4; 364mm.
ln=2 Page length: unlimited length.
df=0 Data compression format: 1-D; modified
Huffman.
df=1 Data compression format: 2-D; modified
Read.
ec=0 Error correction disabled.
ec=1 Enable error correction mode.
bf=0 Disable binary file transfer.
st=0 Minimum scan time/line: 0 ms.
st=1 Minimum scan time/line: 5 ms.
st=2 Minimum scan time/line:10 ms (normal);
5 ms (fine).
st=3 Minimum scan time/line:10 ms.
st=4 Minimum scan time/line:20 ms (normal);
10ms (fine).
st=5 Minimum scan time/line:20 ms.
st=6 Minimum scan time/line:40 ms (normal);
20ms (fine).
st=7 Minimum scan time/line:40 ms.
Current session parameter; refer to +FDCC
command.
Current session negotiation parameter; refer
to +FDCC command.
9-5