Table of Contents
Advertisement
Step 4.
Connect the RJ-45 Ethernet connector (the other end of the special Ethernet cable) into the
POWER & DATA OUT port on the front of the inline power injector.
Step 5.
Connect the antennas or RF cables to the ZyAIR's two antenna ports.
4.8 Attaching Antennas
Follow the steps below to connect the supplied 5dBi Omni-direction rubber antennas.
Step 1.
Locate the antenna connectors on the top of your ZyAIR.
Step 2.
Screw the antennas clockwise onto the antenna connectors. The antennas should be
perpendicular to the ground and parallel to each other.
ZyAIR B-5000 Quick Installation Guide
Figure 17 - Power & Data Out Port
Figure 18 - Antenna Attached
16
Advertisement
Table of Contents
