Table of Contents
Advertisement
Step 2.
Attach the MIL-C-5015 style (RS-232) console cable to the serial port adapter. Connect the
other cable end (DB9 female) to a terminal or a PC running a terminal emulation program.
Step 3.
Connect the female end of the power cord to the inline power injector, and then connect the
male end of the power cord into a power outlet or power strip. The POWER LED on the front
of the Inline power injector should turn on.
Step 4.
Run the Ethernet cable (included in your package) from DATA IN port (on the front panel of
the inline power injector) to the Ethernet port on a computer.
Step 5.
Connect the MIL-C-5015 style Ethernet connector to the special Ethernet port on the bottom of
the ZyAIR.
Step 6.
Connect the RJ-45 Ethernet connector (the other end of the special Ethernet cable) into the
POWER & DATA OUT port on the front of the inline power injector.
When the ZyAIR receives power over the Ethernet cable, the ZyAIR will start its boot sequence and the
ACTIVE LED on the front of the Inline power injector will turn on.
You can configure the ZyAIR using the HTML browser, such as Internet Explorer or Netscape Navigator
from a remote host or PC. See Part I of your ZyAIR User's Guide for a quick setup guide.
ZyAIR B-5000 Quick Installation Guide
Figure 9 - Installation Layout
9
Advertisement
Table of Contents
