Log Commands; Configuring What You Want The Zyxel Device To Log; Displaying Logs; Table 68 Sys Log - ZyXEL Communications ZyXEL NWA3550 User Manual

Chapter 16 Log Screens
Table 67 ICMP Notes (continued)
TYPE
13
14
15
16

Table 68 Sys log

LOG MESSAGE
Mon dd hr:mm:ss hostname
src="<srcIP:srcPort>"
dst="<dstIP:dstPort>"
msg="<msg>" note="<note>"

16.4 Log Commands

Go to the command interpreter interface (see
commands).

16.4.1 Configuring What You Want the ZyXEL Device to Log

Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyXEL Device is to record.
Use sys logs category followed by a log category and a parameter to decide what to record

Table 69 Log Categories and Available Settings Example

LOG CATEGORIES
error
mten
Use 0 to not record logs for that category,
alerts for that category, and
Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order
to record logs).

16.4.2 Displaying Logs

Use the sys logs display command to show all of the logs in the ZyXEL Device's log.
Use the sys logs category display command to show the log settings for all of the log categories.
Use the sys logs display [log category] command to show the logs in an individual ZyXEL
Device log category.
Use the sys logs clear command to erase all of the ZyXEL Device's logs.
200
CODE DESCRIPTION
Pointer indicates the error
0
Timestamp
Timestamp request message
0
Timestamp Reply
Timestamp reply message
0
Information Request
Information request message
0
Information Reply
Information reply message
0
3
to record both logs and alerts for that category.
DESCRIPTION
This message is sent by the "RAS" when this syslog is
generated. The messages and notes are defined in this
appendix's other charts.
Chapter 25 on page 257
AVAILABLE PARAMETERS
0, 1, 2, 3
0, 1
1 to record only logs for that category,
for how to access and use the
2 to record only
NWA3550 User's Guide