Log Commands; Configuring What You Want The Nwa To Log; Displaying Logs - ZyXEL Communications NWA-3500 User Manual

Chapter 19 Log Screens

19.4.2 Log Commands

Go to the command interpreter interface (refer to
discussion on how to access and use the commands).

19.4.3 Configuring What You Want the NWA to Log

Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the NWA is to record.
Use sys logs category followed by a log category and a parameter to decide what to
record
Table 76 Log Categories and Available Settings
LOG CATEGORIES
error
mten
Use to not record logs for that category,
0
record only alerts for that category, and
category.
Use the sys logs save command to store the settings in the NWA (you must do this in
order to record logs).

19.4.4 Displaying Logs

Use the sys logs display command to show all of the logs in the NWA's log.
Use the sys logs category display command to show the log settings for all of the log
categories.
Use the sys logs display [log category] command to show the logs in an individual
NWA log category.
Use the sys logs clear command to erase all of the NWA's logs.
242
Appendix E on page 357
AVAILABLE PARAMETERS
0, 1, 2, 3
0, 1
to record only logs for that category,
1
to record both logs and alerts for that
3
NWA-3500/NWA-3550 User's Guide
for a
to
2