Packet Statistics Window; Figure 35 Packet Statistics Window; Table 27 Packet Statistics Window - ZyXEL Communications Network Device P-2302 User Manual

Table 26 BW MGMT Monitor Window
LABEL
Poll Interval
Set Interval
Stop

4.6 Packet Statistics Window

To access this screen, open the Status screen (see
...) next to Packet Statistics.

Figure 35 Packet Statistics Window

Each field is described in the following table.

Table 27 Packet Statistics Window

LABEL
Port
Status
Tx Pkts
P-2302HWUDL-P1 Series User's Guide
DESCRIPTION
Enter how often you want the ZyXEL Device to update this screen, and click Set
Interval.
Click this to make the ZyXEL Device update the screen based on the amount of
time you specified in Poll Interval.
Click this to make the ZyXEL Device stop updating the screen.
DESCRIPTION
This field displays each port in the ZyXEL Device.
If the port is not connected to anything, this field displays Down.
If the interface uses Ethernet encapsulation, this field displays the port speed and
the Ethernet duplex setting. Duplex settings are:
Full - The ZyXEL Device is using full-duplex Ethernet.
Half - The ZyXEL Device is using half-duplex Ethernet.
You cannot change the Ethernet duplex setting in the ZyXEL Device.
If this interface uses PPPoE encapsulation, this field displays the port speed and
the status of the call.
Down - The connection is not available.
Dial - The ZyXEL Device is making the call.
Idle - The call is connected.
Drop - The ZyXEL Device is ending the call.
The LAN interface always uses Ethernet encapsulation. You can change the
encapsulation of the WAN interface in Network > WAN > Internet Connection.
This field displays the number of packets the ZyXEL Device has transmitted from
the port.
Chapter 4 Status Screens
Section 4.1 on page 67), and click (Details
75