Sip Alg; Nat Screens; Nat General Screen; Figure 63 Network > Nat > General - ZyXEL Communications Network Device P-2302 User Manual

2 Port 7070 is a "trigger" port and causes the ZyXEL Device to record Jane's computer IP
address. The ZyXEL Device associates Jane's computer IP address with the "incoming"
port range of 6970-7170.
3 The Real Audio server responds using a port number ranging between 6970-7170.
4 The ZyXEL Device forwards the traffic to Jane's computer IP address.
5 Only Jane can connect to the Real Audio server until the connection is closed or times
out. The ZyXEL Device times out in three minutes with UDP (User Datagram Protocol),
or two hours with TCP/IP (Transfer Control Protocol/Internet Protocol).
8.1.2.2 Two Points To Remember About Trigger Ports
1 Trigger events only happen on data that is going coming from inside the ZyXEL Device
and going to the outside.
2 If an application needs a continuous data stream, that port (range) will be tied up so that
another computer on the LAN can't trigger it.

8.1.3 SIP ALG

Some NAT routers may include a SIP Application Layer Gateway (ALG). A SIP ALG allows
SIP calls to pass through NAT by examining and translating IP addresses embedded in the
data stream. When the ZyXEL Device registers with the SIP register server, the SIP ALG
translates the ZyXEL Device's private IP address inside the SIP data stream to a public IP
address. You do not need to use STUN or an outbound proxy (see
your ZyXEL Device is behind a SIP ALG.

8.2 NAT Screens

8.2.1 NAT General Screen

Use this screen to enable and disable NAT and to allocate memory for NAT and firewall rules.
To access this screen, click Network > NAT > General.
Figure 63 Network > NAT > General
P-2302HWUDL-P1 Series User's Guide
Chapter 8 NAT
Chapter 9 on page 127) if
119