The Front Panel Leds - ZyXEL Communications Internet Security Gateway ZyWALL 100 Quick Start Manual

LABEL
WIRELESS LAN

The Front Panel LEDs

The PWR LED turns on when you connect the power. The SYS LED blinks while performing system testing
and then stays on if the testing is successful. The CON/AUX, LAN, WAN and WLAN LEDs turn on if they
are properly connected. Refer to the following table for more detailed LED descriptions.
Do not insert or remove a card with the ZyWALL turned on.
Turn off the ZyWALL before inserting or removing an 11 Mbps 802.11b-compliant wireless LAN
PCMCIA card (to avoid damage).
Slide the 64-pin connector end of the PCMCIA wireless LAN card into the slot as shown next.
Do not force, bend or twist the wireless LAN card.
ZyWALL 100
DESCRIPTION
3