Rear Panel; Hardware Installation - ZyXEL Communications Internet Security Gateway ZyWALL 100 Quick Start Manual

Rear Panel

LABEL
1. LAN 10/100M
2. WAN 10/100M
3. POWER 100-
240VAC
After you've made the connections, connect the power cord to a power supply and push the power switch to the on position.
Look at the front panel LEDs.
CONSOLE
DIAL BACKUP
DMZ 10/100M
RESET
Connect a computer to this port with an Ethernet cable. This port is auto-negotiating (can
connect at 10 or 100Mbps). Push the UPLINK button in with a straight-through Ethernet cable or
have the UPLINK button out with a crossover Ethernet cable.
Connect your cable/DSL modem to this port with the cable that came with your modem.
Connect the included power cord (use only this cord) to this power socket.
Only connect this port if you want to configure the ZyWALL using the SMT via console port; see
your User's Guide for details.
Connect the 9-pin male end of the console cable to the console port of the ZyWALL and the
other end to a serial port (COM1, COM2 or other COM port) on your computer. Your computer
should have a terminal emulation communications program (such as HyperTerminal) set to
VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow control and 9600 bps port
speed.
Only connect this port if you want to set up a backup WAN connection; see your User's Guide for
details.
Connect the 9-pin female end of your modem or TA cable to this port and the other end to your
modem or TA.
Connect publicly accessible servers (Web, FTP, etc.) to this port to make them visible to the
outside world. Use a crossover Ethernet cable to connect this port to a single computer.
For multiple computers, use a straight-through Ethernet cable to connect this port to a hub.
You only need to use this button if you've forgotten the ZyWALL's password. It returns the
ZyWALL to the factory defaults (password is 1234, LAN IP address 192.168.1.1, terminal
emulation settings as described above etc.; see your User's Guide for details).
ZyWALL 100

Hardware Installation

DESCRIPTION
2